Hard disk drive (HDD) / solid state disk (SSD)
Installing the new HDD/SSD backplane
Figure 167: Installing the HDD/SSD backplane
▶ At a slight angle, fit the HDD/SSD backplane into the six recesses in the
HDD extension box (1).
▶ Fold down the HDD/SSD backplane (2).
▶ Fasten the HDD/SSD backplane with four screws (see
▶ Install the 8x 2.5-inch HDD/SSD extension box, see
HDD/SSD extension box" on page
Concluding steps
▶ Install the fan bridge, see
▶
"Installing the system air duct" on page
▶
"Reassembling" on page
▶ Install all HDD/SSD modules or dummy modules into their original slots in
the HDD/SSD extension box, see
on page 218
and
▶
"Connecting the power cord" on page
276
266.
"Handling the fan bridge" on page
68.
"Installing 2.5-inch HDD/SSD modules"
"Installing a 2.5-inch dummy module" on page
Upgrade and Maintenance Manual
Figure
"Installing a 8x 2.5-inch
68.
82.
165).
92.
222.
TX2550 M5