Replacing The Irmc Microsd Card - Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

System board and components
▶ To eject the iRMC microSD card, gently push it in and then let go (1).
▶ Pull the iRMC microSD card straight out of its slot (2).
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
Concluding steps
▶ If applicable, install the expansion card in slot 5 and 6, see
expansion card" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
16.5.4

Replacing the iRMC microSD card

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (for cover 2)
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
494
256.
60.
65.
69.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 20 minutes
(Firmware restore:
depending on configuration)
49.
"Installing the
69.
52.
RX2540 M6