Replacing The Sas Expander Board; Hdd/Ssd Modules) - Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state disk (SSD)
Concluding steps
▶ Install the fan bridge, see
▶
"Installing the system air duct" on page
▶ Insert all HDD/SSD modules, see
on page 219.
Ensure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
▶ Insert all dummy modules, see
module" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
7.5.11 Replacing the SAS expander board (configuration
with up to 32 HDD/SSD modules)
Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Removing the system air duct" on page
▶ Remove the fan bridge, see
258
"Handling the fan bridge" on page
"Installing a 2.5-inch HDD/SSD module"
"Installing a 2.5-inch HDD/SSD dummy
222.
68.
83.
"Handling the fan bridge" on page
Upgrade and Maintenance Manual
68.
82.
Hardware: 15 minutes
47.
49.
50.
51.
67.
92.
92.
TX2550 M5