Table of Contents
Advertisement
14.5.4
Replacing the iRMC microSD card
Upgrade and Repair Unit
(URU)
– Phillips PH2 / (+) No. 2 screw driver (for housing cover)
Tools:
– a pair of side-cutting pliers
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove the riser module 6/7, see
on page
61.
▶
"Removing the riser module" on page
Replacing the iRMC microSD card
▶ Remove the defective iRMC microSD card, see
microSD card" on page
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
▶ Install the new iRMC microSD card, see
on page
327.
RX4770 M5
45.
"Removing the riser module 3/4 and 6/7"
64.
329.
Upgrade and Maintenance Manual
System board and components
Hardware: 5 minutes
43.
46.
47.
"Removing the iRMC
"Installing the iRMC microSD card"
331
Advertisement
Table of Contents
