Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual page 229

Removing a 2.5-inch PCIe SSD module
Figure 129: Opening the locking lever
▶ Pinch the green locking clips (1) and open the locking lever (2).
▶ Pull the PCIe SSD module completely out of its bay.
Installing a 2.5-inch dummy module
CAUTION
▶
If the removed HDD/SSD module is not replaced immediately,
always replace a dummy module into the unused HDD/SSD bay to
comply with applicable EMC regulations and satisfy cooling
requirements.
Figure 130: Installing the 2.5-inch dummy module
TX2550 M5
Hard disk drive (HDD) / solid state disk (SSD)
Upgrade and Maintenance Manual 229