Switching On The Server - Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual

Figure 34: Locking the cable clamp of a PSU
▶ Pull the cable clamp up (1).
▶ Thread the power cord through the cable clamp (2).
▶ Press the cable clamp down until it engages to secure the cable (3).
It will take about 60 seconds until the server can be powered on.
4.7

Switching on the server

CAUTION
▶
Before switching on the server, make sure the top cover is closed.
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top cover is removed.
▶
For more information, see
▶ Press the On/Off button to start up the server.
▶ Ensure that the power-on indicator is lit green.
TX2550 M5
"Important information" on page
Upgrade and Maintenance Manual
Basic hardware procedures
33.
83