The Login Screen; Command Syntax Conventions; Figure 152 Cli: Login Screen - ZyXEL Communications GS-4012F/4024 User Manual

3 A login screen displays (refer to

40.3 The Login Screen

After you have successfully established a connection to the switch using a direct console
connection or Telnet, a login screen displays as shown below. For your first login, enter the
default administrator login username "admin" and password "1234".

Figure 152 CLI: Login Screen

40.4 Command Syntax Conventions

The rules of the commands are listed next.
• The command keywords are in
• The required fields in a command are enclosed in angle brackets <>, for instance,
means that you must specify an IP number for this command.
<ip>
• The optional fields in a command are enclosed in square brackets [], for instance,
means that the
• "Command" refers to a command used in the command line interface (CI command).
• The | symbol means "or".
• The entry
return after a command to execute the command.
• Use the up ( ) or down ( ) arrow key to scroll through the command history list.
• The CLI does not accept partial or incomplete commands. You may enter a unique part of
a command and press
For example, if you enter "
automatically displays.
• Each interface refers to an Ethernet port on the switch. Commands configured after the
interface command correspond to those ports.
• Type multiple ports or port ranges separated by a comma. Ranges of port numbers are
typed separated by a dash.
Chapter 40 Introducing the Commands
Section 40.3 on page
Enter User Name : admin
Enter Password : XXXX
courier new
configure snmp-server [contact <system contact>] [location
<system location>]
and
contact location
in the command lines refers to carriage return. Press
<cr>
to have the switch automatically display the full command.
[TAB]
config
238).
font.
fields are optional.
" and press , the full command of "
[TAB]
GS-4012F/4024 User's Guide
ping
or carriage
[ENTER]
configure
"
238