Chapter 23 Static Route; Configuring; Figure 74 Static Routing; Table 51 Static Routing - ZyXEL Communications GS-4012F/4024 User Manual

This chapter shows you how to configure static routes.

23.1 Configuring

Static routes tell the switch how to forward IP traffic when you configure the TCP/IP
parameters manually.
Click IP Application, Static Routing in the navigation panel to display the screen as shown.

Figure 74 Static Routing

The following table describes the related labels you use to create a static route.

Table 51 Static Routing

LABEL
Active
Name
Destination IP
Address
IP Subnet Mask Enter the subnet mask for this destination.
Gateway IP
Address

Chapter 23 Static Route

DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
switch that will forward the packet to the destination. The gateway must be a router on
the same segment as your switch.
GS-4012F/4024 User's Guide
C
H A P T E R
Static Route
2 3
156