Vrrp Configuration Summary; Vrrp Configuration Examples; One Subnet Network Example; Figure 105 Vrrp Configuration: Summary - ZyXEL Communications GS-4012F/4024 User Manual

GS-4012F/4024 User's Guide

31.4 VRRP Configuration Summary

To view a summary of all VRRP configurations on the switch, scroll down to the bottom of the
VRRP Configuration screen.

Figure 105 VRRP Configuration: Summary

The following table describes the labels in this screen.

Table 75 VRRP Configuring: VRRP Parameters

LABEL
Index
Active
Name
Network
VRID
Primary VIP
Uplink Gateway This field displays the IP address of the uplink gateway.
Priority
Delete
Cancel

31.5 VRRP Configuration Examples

The following sections show two VRRP configuration examples on the switch.

31.5.1 One Subnet Network Example

The figure below shows a simple VRRP network with only one virtual router VR1 (VRID =1)
and two switches. The network is connected to the WAN via an uplink gateway G
(172.21.1.100). The host computer X is set to use VR1 as the default gateway.
195
DESCRIPTION
This field displays the index number of an entry.
This field shows whether a VRRP entry is enabled (Yes) or disabled (No).
This field displays a descriptive name of an entry.
This field displays the IP address and subnet mask of an interface.
This field displays the ID number of a virtual router.
This field displays the IP address of the primary virtual router.
This field displays the priority level (1 to 255) of the entry.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
Chapter 31 VRRP