ZyXEL Communications GS-4012F/4024 User Manual page 258

Table 95 Command Summary: Configuration Mode (continued)
COMMAND
rip
vrrp network <ip-
address>/<mask-bits>
vr-id <1-7> uplink-
gateway <ip>
Chapter 40 Introducing the Commands
no area <area-id>
virtual-link
<router-id>
authentication-
same-as-area
no area <area-id>
virtual-link
<router-id>
no network <ip-
addr/bits>
no redistribute
rip
no redistribute
static
redistribute rip
metric-type <1|2>
metric <0-65535>
redistribute
static metric-
type <1|2> metric
<0-65535>
exit
exit
inactive
interval <1..255>
name <name
string>
no inactive
no preempt
no primary-
virtual-ip
no secondary-
virtual-ip
GS-4012F/4024 User's Guide
DESCRIPTION
Resets the authentication
settings on this virtual area.
Deletes the virtual link from the
area.
Deletes the OSPF network.
Sets the switch not to learn RIP
routing information.
Sets the switch not to learn
static routing information.
Sets the switch to learn RIP
routing information which will
use the specified metric
information.
Sets the switch to learn static
routing information which will
use the specified metric
information.
Enables and enters the RIP
configuration mode.
Leaves the RIP configuration
mode.
Adds aa new VRRP network nd
enters the VRRP configuration
mode.
Exits from the VRRP command
mode.
Disables the VRRP settings.
Sets the time interval (in
seconds) between Hello
message transmissions.
Sets a descriptive name of the
VRRP setting for identification
purposes.
Activates this VRRP.
Disables VRRP preemption
mode.
Resets the network to use the
default primary virtual gateway
(interface IP address).
Sets the network to use the
default secondary virtual
gateway (0.0.0.0).
258