Reload The Configuration File; Logging Out Of The Web Configurator; Figure 21 Resetting The Switch: Via The Console Port - ZyXEL Communications GS-4012F/4024 User Manual

GS-4012F/4024 User's Guide

4.5.1 Reload the Configuration File

Uploading the factory-default configuration file replaces the current configuration file with the
factory-default configuration file. This means that you will lose all previous configurations
and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no
parity, one stop bit and flow control set to none. The password will also be reset to "1234" and
the IP address to 192.168.1.1.
To upload the configuration file, do the following:
1 Connect to the console port using a computer with terminal emulation software. See
Section 3.1.1 on page 45
2 Disconnect and reconnect the switch's power to begin a session. When you reconnect the
switch's power, you will see the initial screen.
3 When you see the message "
seconds ...
4 Type
atlc
5 Wait for the "
upload on your terminal.
6 After a configuration file upload, type

Figure 21 Resetting the Switch: Via the Console Port

Bootbase Version: V1.0 | 11/26/2004 15:56:35
RAM:Size = 64 Mbytes
FLASH: Intel 32M
ZyNOS Version: V3.60(LL.0)b2 | 01/18/2005 00:39:28
Press any key to enter debug mode within 3 seconds.
....................
Enter Debug Mode
GS-4012F> atlc
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total 393216 bytes received.
Erasing..
................................................................
OK
GS-4012F> atgo
The switch is now reinitialized with a default configuration file including the default password
of "1234".

4.6 Logging Out of the Web Configurator

Click Logout in a screen to exit the web configurator. You have to log in with your password
again after you log out. This is recommended after you finish a management session for
security reasons.
57
for details.
Press any key to enter Debug Mode within 3
" press any key to enter debug mode.
after the "
Enter Debug Mode
Starting XMODEM upload
" message.
" message before activating XMODEM
to restart the switch.
atgo
Chapter 4 The Web Configurator