Figure 48 Link Aggregation Control Protocol: Configuration; Table 30 Link Aggregation Control Protocol: Configuration - ZyXEL Communications GS-4012F/4024 User Manual

GS-4012F/4024 User's Guide

Figure 48 Link Aggregation Control Protocol: Configuration

The following table describes the labels in this screen.

Table 30 Link Aggregation Control Protocol: Configuration

LABEL
Link Aggregation Control Protocol
Active
System
Priority
Group ID
Active
Dynamic
(LACP)
Port
Group
113
DESCRIPTION
Select this checkbox to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65,535. The switch with the lowest
system priority (and lowest port number if system priority is the same) becomes the
LACP "server". The LACP "server" controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link Aggregate Control Protocol
(LACP). The smaller the number, the higher the priority level.
The field identifies the link aggregation group, that is, one logical link containing
multiple ports
Select this option to activate a trunk group.
Select this check box to enable LACP for a trunk.
This field displays the port number.
Select the trunk group to which a port belongs.
Chapter 15 Link Aggregation