Teledyne SyriXus 65x Installation And Operation Manual page 167

Command (Refer to
NOTE 1 & NOTE 2
.)
REFILL=#
REFILLB=#
REFILLC=#
REFILLD=#
REMOTE
RLIMITA
RLIMITB
RLIMITC
RLIMITD
RSVP
RSVPB
RSVPC
RSVPD
RUN
RUNB
RUNC
RUND
RUNALL
SETFLOWA
SETFLOWB
SETFLOWC
SETFLOWD
SETPRESSA
SETPRESSB
SETPRESSC
SETPRESSD
STATUSA
STATUSB
STATUSC
STATUSD
STOP
STOPB
STOPC
STOPD
STOPALL
UNITSA=
VOLA
VOLB
VOLC
VOLD
VOLTOT
VOLTOTCD
VOL RESET
VOL RESETCD
EAR99 Technology Subject to Restrictions Contained on the Cover Page
SyriXus Series Pumps Installation and Operation Guide
Table 8-3 Serial Commands (Continued)
Enter # to designate refill rate.
Disables controller front panel control and enables all serial commands. Stops all
motors (if control was previously local).
Returns the refill flow rate limit.
Pump responds with 'READY' message.
Same as front panel. Initiates pumping.
Returns the flow rate setpoint.
Returns the pressure setpoint.
Returns with status of pump. May be any combination of responses listed below.
STATUS=
STOP
RUN
REFILL
HOLD
EQUIL.
LOCAL
REMOTE
EXTERNAL
Same as front panel with the exception that pump remains under remote serial con-
trol.
Enter the desired flow or pressure units after the equal sign. Acceptable values are:
ATM, BAR, KPA, PSI, ML/MIN, ML/HR, UL/MIN, UL/HR. (Sets all pumps.)
Return the volume remaining in cylinder in mL. Format is 'XXX.XXXX' mL.
Returns the total volume delivered when using continuous flow or modifier.
Will reset the volume total to zero.
Section 8 Serial Interface
Description
PROBLEM=
OVER PRESSURE
UNDER PRESSURE
CYLINDER FULL
CYLINDER EMPTY
MOTOR FAILURE
8-25