Syringe Pump Cylinder Cap: Attach To Pressure Transducer Connector On Back Of Pump; Connecting The Pump And Controller - Teledyne SyriXus 65x Installation And Operation Manual

Transducer Cap
Assembly for the 65x
Figure 1-8 Syringe pump cylinder cap: Attach to pressure transducer
connector on back of pump.
Controller
Figure 1-9 Connecting the pump and controller
EAR99 Technology Subject to Restrictions Contained on the Cover Page
SyriXus Series Pumps Installation and Operation Guide
The pressure transducer cable length is always 6 feet (1.8 m).
Never attempt to extend the length of this cable.
The FIRST (or ONLY) pump must be connected to 'PUMP A'.
Never make any cable connections while the pump is powered ON.
Section 1 Introduction
Transducer Cable, 6 ft (1.8 m)
Caution
Pump
Pressure
Transducer
Connector
NOTE
Caution
1-17