Teledyne SyriXus 65x Installation And Operation Manual page 166

SyriXus Series Pumps Installation and Operation Guide
Section 8 Serial Interface
Command (Refer to
NOTE 1 & NOTE 2
MODE
MODIFIER
PRESS=#
PRESSB=#
PRESSC=#
PRESSD=#
PRESS
PRESSCD
PRESSA
PRESSB
PRESSC
PRESSD
PRESSCNTRLDIFF1
PRESSCNTRLDIFF1=XXXXX
PRESSCNTRLDIFF2
PRESSCNTRLDIFF3
PRESSCNTRLNORM
PRESSDIFF=XXXXX
PRESSDIFF
RANGEA
RANGEB
RANGEC
RANGED
RAPIDA
RAPIDB
RAPIDC
RAPIDD
RECEIVE
RECEIVECD
REFILL
REFILLB
REFILLC
REFILLD
EAR99 Technology Subject to Restrictions Contained on the Cover Page
8-24
Table 8-3 Serial Commands (Continued)
.)
MODE A P, B P, C P, D P
A, B, C, D refer to the pump connection.
P- Constant Pressure
F- Constant Flow
R- Refill
PG- Pressure Gradient
F1- Flow Gradient 1 Pump
F2- Concentrated Gradient 2 Pump
CF- Continuous Constant Flow
CP- Continuous Constant Pressure
MO- Modifier Mode 2 Pump
MM- Modifier Mode 3 Pump
Put pumps in Modifier Addition Mode.
Enter # to designate pressure setpoint (Constant Pressure Mode).
Returns the delivering pump pressure in continuous pumping mode and Modifier
Addition Mode. In INDEPENDENT Mode PRESS returns the pump A pressure and
PRESSCD returns the pump C pressure.
Returns the actual pressure of the pump.
Sets the pressure control input to Analog input 1, with a pressure range of 50 psi.
Sets the pressure control input to Analog input 1 and sets the pressure range. The
range is 1 to 5000. the units are psi, with a value of 5000 representing 5000 psi at 5
volts.
Sets the pressure control input to Analog input 2, with a pressure range of 500 psi
at 5 volts.
Sets the pressure control input to Analog input 2, with a pressure range of 5000 psi
at 5 volts.
Sets the pressure control input to the standard input.
Differential pressure setpoint. (PSI*10) 0 to 50,000 maximum (0 to 5000 psi)
Reads the differential pressure value. (PSI*10) The transducer can also be read via
the 'ALOGx' serial commands.
Provides scaling information for the system parameters. Refer to Section 8.8.4
"Range Command" for more information about this serial command.
Activates the automatic rapid pressurization cycle (Constant Flow Mode only).
Set the dual-pump mode to receive fluid when running.
Move cylinder to bottom at preset refill rate.
Description