Serial Control Check List; Controller Setup; Restore Defaults (If Desired); Change Defaults - Teledyne SyriXus 65x Installation And Operation Manual

SyriXus Series Pumps Installation and Operation Guide
Section 8 Serial Interface
8.5 Serial Control
Check List

8.6 Controller Setup

8.6.1 Restore Defaults (If
Desired)

8.6.2 Change Defaults

EAR99 Technology Subject to Restrictions Contained on the Cover Page
8-6
In order to build and operate a custom program for Teledyne ISCO
syringe pumps, you must have the following:
1. Sample program
2. LabView Compiler (optional - purchased separately)
3. Connection cable(s)
4. One (1) controller: cable 480-7996-00
5. Two (2) controllers: 'Y' cable from a computer parts store
6. Three (3) to seven (7) controllers: No longer supported
7. Source code (serial commands in your preferred computer lan-
guage for DASNET conversion)
8. DASNET serial driver (for LabVIEW connection)
Other programming languages capable of reading and writing ASCII
codes through a serial port could be used instead. However,
because of the wide range of operating systems and computer pro-
gramming languages available, Teledyne ISCO cannot provide sup-
port or programming assistance for user developed control systems.
Once the system is properly connected, turn the pump(s), controller(s)
and computer ON. Then use the following procedure to place your con-
troller(s) in serial control mode.
Press > (A) and select
MENU MORE
default settings are baud rate 9600 and unit ID #6.
To restore defaults, press
system erases all programs and user settings stored in the con-
troller.
1. Press MENU > MORE (A) > 1. Serial Option to enter the serial
option setup screen.
2. Select the communication baud rate (between 300 and 115.2K)
by pressing
NEXT BAUD
All units in the network must be set to the SAME baud rate and be
assigned a different unit.
3. Select an identification number for each controller (up to seven)
by pressing
NEXT ID
Multiple controllers in a network must each have a different ID num-
ber.
NOTE
(1). Factory controller
SERIAL
, then
MENU SYSTEM RESET
(A) until you reach the desired baud rate.
NOTE
# (B) until you reach the desired number.
NOTE
(5). Resetting a