9
8
7
6
Figure 1-5 Pump controller rear panel connectors
Table 1-8 Pump Controller Rear Panel Connectors
Figure 1-5 #
Connector
1
2
3
4
5
ACCESSORY
EAR99 Technology Subject to Restrictions Contained on the Cover Page
SyriXus Series Pumps Installation and Operation Guide
For more information on the keypad, refer to Section 3.8 "Front
Panel Keys".
10
5
PUMP D
This connector is only used during multiple pump operation. The con-
trol cable from the rear panel of the fourth pump is attached to this con-
nector.
PUMP C
This connector is only used during multiple pump operation. The con-
trol cable from the rear panel of the third pump is attached to this con-
nector.
PUMP B
This connector is only used during multiple pump operation. The con-
trol cable from the rear panel of the second pump is attached to this
connector.
PUMP A
This plug connects the control cable from the pump rear panel. This
connection should be secured with the thumbscrews.
IMPORTANT: The pump A connector is the only input power connec-
tor on the rear panel of the controller. During single-pump operation,
the pump must be attached to this connector to supply power to the
controller.
WARNING: Do not connect or disconnect the control cable when
the pump is connected to the mains voltage.
These terminals allow connection of input and output signals (such as
analog controls and external RUN/STOP).
Section 1 Introduction
NOTE
11
Description
1
2
3
4
1-11