Teledyne SyriXus 65x Installation And Operation Manual page 102

SyriXus Series Pumps Installation and Operation Guide
Section 5 Continuous Flow Introduction, Installation, and Operation
EAR99 Technology Subject to Restrictions Contained on the Cover Page
5-4
One controller can operate up to two pairs of pumps and control the
valves at the same time. The black wires of the valve assembly on the
first pair of pumps need to be attached to the DIGITAL OUTPUT con-
nectors labeled 'A' and 'B'; and the black wires on the second pair of
pumps and valve assembly need to be attached to the 'C' and 'D' con-
nectors. Refer to Table 5-3 "ALL Dual Air SyriXus Pumps - Con-
version Table for A-B Pump Pair and C-D Pump Pair" to identify
which wire goes to which port.
When only one pair of pumps is attached, the actuator wires MUST
be connected to the DIGITAL OUTPUT connectors labeled 'A' and
'B'; and the pumps MUST be attached to the 'PUMP A' and 'PUMP
B' connectors. Refer to Figure 1-6 for identification of the controller
back panel connectors.
NOTE