Actuator Wire Labels; All Dual Air Syrixus Pumps - Conversion Table For A-B Pump Pair And C-D Pump Pair - Teledyne SyriXus 65x Installation And Operation Manual

SyriXus Series Pumps Installation and Operation Guide
Section 5 Continuous Flow Introduction, Installation, and Operation
Conversion Table for A-B Pump Pair and C-D Pump Pair
A-B Pump Wire Digital
Pair Output
A1
A2
B1
B2
Figure 5-2 Actuator wire labels
EAR99 Technology Subject to Restrictions Contained on the Cover Page
5-6
Table 5-3 ALL Dual Air SyriXus Pumps -
+15 wires
(Red)
A1 +15
A2 +15
B3 +15
B4 +15
Teledyne ISCO has historically identified the pump to the left of the
dual valve assembly as 'A' ('C') and the one to the right of the valve
assembly as 'B' ('D') when facing the front of the equipment. The
valve control software assumes this arrangement, and the pumps
must be plugged into the connectors on the back of the controller
corresponding to this identification.
The black wires on the actuator are labeled 'A1', 'A2', 'B1' and 'B2' and
the red wires are labeled '+15'. If the labels are missing or damaged,
refer to Figure 5-2 to identify the wires.
C-D Pump Wire
Digital Output
Pair
A1
A2
B1
B2
NOTE
+15 Wires
(Red)
C5 +15
C6 +15
D7 +15
D8 +15