Section 4 Gradient Pumping For Pressure, Flow, And Concentration Modes; Introduction; Tools And Parts For Single-Pump System; Tools And Parts For Dual-Pump System - Teledyne SyriXus 65x Installation And Operation Manual

SyriXus Series Pumps Installation and Operation Guide
Section 4 Gradient Pumping for Pressure, Flow, and Concentration
Modes

4.1 Introduction

4.1.1 Tools and Parts for
Single-Pump
System
4.1.2 Tools and Parts for
Dual-Pump System
EAR99 Technology Subject to Restrictions Contained on the Cover Page
Gradient pumping is used in applications requiring time-controlled or
rate-controlled delivery of a specific volume at a set flow rate or
pressure, or a two-pump flow concentration.
All Teledyne ISCO syringe pump models can be used in Gradient
Mode, but SyriXus model 65x requires special hardware for this mode.
Contact Teledyne ISCO Customer Service using the information in 9.3
"Customer Service Department".
You can program the controller to increase or decrease pressure or
flow during different steps within a single program by entering a spe-
cific value at the beginning and end of each step.
RISK OF INJURY. THE PRESSURE PRODUCED
COULD BE
APPROPRIATE TUBING AND CONNECTIONS NOTED
IN THE MANUAL.
• Open-end wrenches: 1/4", 5/16", 7/16", 3/8"
• Manual Refill Valve Kit - Refer to Table 4-1 "Manual Refill
Valve Kits"
• Manual Outlet Valve Kit - Refer to Table 4-2 "Manual Outlet
Valve Kits"
• Open-end wrenches: 1/4", 5/16", 7/16", 3/8"
• Manual Refill Valve Kit - Refer to Table 4-1 "Manual Refill
Valve Kits" (two kits required)
DANGER
700 BAR. PLEASE UTILIZE
4-1