Handoff Waveform Quality Measurement Troubleshooting; Possible Setup Issues; Interpreting Integrity Indicator Values; Related Topics - Agilent Technologies 8960 Series Reference Manual

Handoff Waveform Quality Measurement Troubleshooting

Possible Setup Issues

If a handoff waveform quality measurement is attempted while in active cell operating mode, a call must be
connected so that long code information can be obtained from the mobile station and measurement triggers
can be synchronized to the CDMA frame clock inside the test set.
A radio configuration 3 (F3R3) or radio configuration 4 (F4R3) call must be connected.
The START SINGLE key initiates a handoff waveform quality measurement from the front panel
(see"Measuring Handoff Waveform Quality"
IMPORTANT If the Access Probe Power measurement is currently selected and the Trigger Arm setting is
Continuous, all other measurements are disabled. Use the
command to set the trigger arm state to single and retry this measurement.
The test set receiver's expected signal amplitude and channel number (or frequency) must be set up correctly
for accurate measurements. This is normally done automatically (see
also be done manually (see

Interpreting Integrity Indicator values

An integrity indicator of 17 (Can not correlate), indicates that the received signal did not correlate with an
internally generated reference signal. See

Related Topics

"Integrity Indicator" on page 222
"Handoff Waveform Quality Measurement Description"
for manual measurement instructions).
"Receiver Control" on page
"Integrity Indicator" on page
Handoff Waveform Quality Measurement Troubleshooting
"Active Cell Operating Mode"
194) .
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_ts_hwquality.fm
"SETup:CAPPower:CONTinuous"
222.
) but can
714