Agilent Technologies 8960 Series Reference Manual page 590

STATus:OPERation:
Bit Binary
Number Weighting
3 8
2 4
1 2
0 1
Program Examples - STATus:OPERation:NMRReady:CDMA
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:EVENT?" !Queries the New Measurement
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:CONDITION?" !Queries the New Measurement
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:ENABLE 8" !Sets New Measurement Results
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:NTR 2" !Sets the New Measurement Results
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:PTR 4" !Sets the New Measurement
590
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_status_operation.fm
Condition
CPOWer New Measurement
Result Ready
WQUality New Measurement
Result Ready
DAPower New Measurement
Result Ready
Extension Bit
This bit is a 1 if the measurement has been
completed and has produced new results.
This bit is a zero at power on, after a preset and
while a measurement is in Measuring States. See
"Triggering of Measurements" on page
This bit is a 1 if the measurement has been
completed and has produced new results.
This bit is a zero at power on, after a preset and
while a measurement is in Measuring States. See
"Triggering of Measurements" on page
This bit is a 1 if the measurement has been
completed and has produced new results.
This bit is a zero at power on, after a preset and
while a measurement is in Measuring States. See
"Triggering of Measurements" on page
This bit is always 0.
!Results Ready CDMA Event Register.
!Results Ready CDMA
!Condition Register.
!Ready CDMA Enable Regigter
!for bit 3.
!Ready CDMA Negative Transition
!Register for bit 1.
!Results Ready CDMA Positive
!Transition Register
!for bit 2
Description
218.
218.
218.