Measuring Handoff Waveform Quality - Agilent Technologies 8960 Series Operation Manual

Measuring Handoff Waveform Quality

Each waveform quality measurement returns a number of measurements which
includes rho.
These measurements can be made only when one of the following radio
configurations (see
• (Fwd3, Rvs3)
• (Fwd4, Rvs3)
1. Select the Handoff Waveform Quality measurement (see
measurements." on page
2. Set up the measurement parameters (Measurement Timeout is the only
parameter provided with this measurement) as needed for your measurement
situation (see "B. Set up the measurement." on page
3. Press the
START SINGLE
In addition to rho, the waveform quality measurement also provides the following
measurements, calculated from the same data:
• Time Error
• Carrier Feedthrough
• Phase Error
• Magnitude Error
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started
"How Do I Set Up a Call?" on page
48).
key. A typical display is shown below.
cdma2000 Measurement Procedures
52) is selected:
"B. Select
50.)
71