Measurement Requirements; Related Topics - Agilent Technologies 8960 Series Reference Manual

Measurement Requirements

Setup:
The following settings are required for the handoff waveform quality measurement:
• Operating Mode must be Active Cell
• System Type must be IS-2000 with Radio Config set to (Fwd3, Rvs3) or (Fwd4, Rvs3)
• A call must be connected
Input Signal:
The handoff waveform quality measurement meets or exceeds specifications when the following input signal
requirements are met:
• The frequency of the signal being measured must be in the range of 412 MHz to 483 MHz, 800 MHz to 960
MHz, or 1.7 GHz to 2.0 GHz, and within 100 kHz of the expected frequency.
• The signal level into the test set's RF IN/OUT connector must be in the range of -25 dBm to +37 dBm, and
within 9 dBm of the expected input power (see
specifications.

Related Topics

"Programming a Handoff Waveform Quality Measurement"
"SETup:HWQuality"
"FETCh:HWQuality"
"INITiate"
"READ"
"ABORt"
"Test Adherence to Standards"
"Handoff Waveform Quality Measurement Troubleshooting"
"RFANalyzer:AUTO:POWer[:SELected]?"
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_meas_hwq_desc.fm
Handoff Waveform Quality Measurement Description
) to meet
63