Agilent Technologies 8960 Series Reference Manual page 637

SYSTem:COMMunicate:GPIB:DEBug[:STATe]
Function Sets/queries the test set's SCPI debugger state.
When the state is on; enhanced error messages (generated from GPIB commands with syntax
errors) are shown the test set display.
The error message is printed along with the syntax. <ERR> is displayed at the end of the
incorrect node. Non-printable characters will be replaced with the $ symbol. See
Messages" on page 719
The debugger state should be set to on only during GPIB code development. Test times will
increase if the debugger state is left on.
Setting Range: 0|OFF | 1|ON
Query 0|1
*RST setting 0|off
Programming Example
OUTPUT 714;"SYSTEM:COMMUNICATE:GPIB:DEBUG:STATE ON" !Sets debugger to on.
SYSTem:COMMunicate:LAN[:SELF]:ADDRess
Function Sets/queries the test set's LAN IP address. The value of A is used to determine the subnet mask,
see "SYSTem:COMMunicate:LAN[:SELF]:SMASk" on page
If the LAN address is changed the subnet mask should be checked to insure that it is set to the
proper class for that LAN address.
Setting Range: 15 characters formatted as follows: A.B.C.D where A= 0 to 223 B,C,D = 0 to 255 (no
embedded spaces)
Query Range: 15 characters formatted as follows: A.B.C.D where A= 0 to 223 B,C,D = 0 to 255 (no
embedded spaces)
Factory 0.0.0.0 (this parameter is not affected by any reset operation and can only be changed by direct
setting user access)
"Configuring the Test Set's LAN" on page 772
Related
Topics
Programming Example
OUTPUT 714;"SYSTEM:COMMUNICATE:LAN:SELF:ADDRESS '130.015.156.255'" !Sets the
for a list of the errors.
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_system_communicate.fm
SYSTem:COMMunicate
"Error
638.
!LAN IP
!address.
637