Cleaning Fiber Optic Connectors And Cables - Extron electronics Quantum Ultra Series User Manual

Cleaning Fiber Optic Connectors and Cables

To obtain optimum optical performance, ensure the fiber optic cables and connectors
are properly cleaned. Both the fiber and connector ends should be cleaned immediately
before connecting.
WARNING:
ADVERTISSEMENT :
Always handle, use, and dispose of chemicals in accordance with the safety
•
instructions of the manufacturer. Some chemicals may be toxic if swallowed.
• Toujours manipuler, utiliser, et jeter les produits chimiques conformément aux
consignes de sécurité du fabricant. Certains produits chimiques peuvent être
toxiques en cas d'ingestion.
Ensure that no optical signal is present in the fiber during cleaning. Always be
•
certain the cable is disconnected at both ends and the equipment is off prior to
cleaning.
Assurez-vous que aucun signal optique n'est présent dans la fibre lors du
•
nettoyage. Il est important de veiller à ce que le câble soit toujours déconnecté
aux deux extrémités et que l'équipement soit hors tension avant le nettoyage.
Connectors
1. Moisten a lint-free wipe with alcohol (damp, but not saturated), or use a
pre-moistened wipe.
2. Wipe the ferrule end-face in a twisting and wiping motion.
3. Repeat twice, using a clean area of the dampened wipe each time.
4.
Repeat wiping action using a dry lint-free wipe.
5. Inspect the end-face under magnification (100x minimum) to ensure debris and
contaminants are removed.
Cables
1. Moisten the end of a lint-free swab with alcohol.
2. Remove excess alcohol from the swab with a dry, clean wipe.
3. Insert the swab into either end of the cable.
4. Clean, using a scrubbing motion.
5. Remove the swab using a rotating motion.
6. Using clean, compressed air, blow out the cable until dry.
WARNING:
ADVERTISSEMENT :
Always wear eye protection when using compressed air.
•
Veillez à toujours porter des lunettes de protection lorsque vous utilisez de l'air
•
comprimé.
Never inspect or look into the end of terminated fibers while the cables are
•
connected to equipment as invisible laser radiation may damage eye tissue.
Ne jamais inspecter ni regarder le bout des fibres raccordées lorsque les câbles
•
sont connectés aux équipements car le rayonnement laser invisible peut entraîner
des lésions oculaires.
Quantum Ultra Series Videowall Processing Systems • Reference 113 113