Table of Contents
Advertisement
im Vertrieb von
Installation and Operation, cont'd
Remove (2)
Screws
Figure 4 — Setting the gain/peaking jumpers
2.
3.
4.
Attaching output cables
After the circuit board switches have been set, attach the cables that will be
inaccessible after installation.
Audio output connector
The 3.5 mm, 5-pole captive screw (Phoenix) connector is used
for balanced/unbalanced audio output. Attach the five
wires for audio output of ground, left, and right channels to
the connector; follow the wiring guide shown in figure 5.
Insert the wires into the appropriate openings. Tighten the
screws to fasten the wires.
www.camboard.de
2-6
RGB 500 AKM and RGB 560 AKM Installation and Operation
CAMBOARD Electronics
H. SHIFT
MIN/MAX
Remove (2)
Screws
Front Face
Locate the gain/peaking jumpers on the wider of the two circuit boards
attached to the back of the faceplate (figure 4). J16 controls blue
gain/peaking, J17 controls red, and J18 controls green.
Using needlenose pliers to reach and move the jumpers, set the jumpers to
the positions that yield the best image display.
•
Use pins 3 and 4 to increase the output signal and add 50%
of the maximum peaking to the signal.
•
Use pins 2 and 3 for unity output (0.7 volts, no peaking; the
default).
•
Use pins 1 and 2 to increase the output signal and add
100% of the maximum peaking to the signal for very long
cable runs.
Reattach the faceplate to the enclosure by reinstalling the screws you
removed in step 1.
Tel. 07131 911201
Fax 07131 911203
AUDIO
INPUT
BUFFERED
LOCAL OUT
RGB 560 AKM with ADSP
TM
Remove (2)
J18
Screws
J17
J16
Use Needlenose Pliers
to move jumpers
PC Board
(Inside)
ce-info@camboard.de
4
1
4
1
4
1
Advertisement
Table of Contents
