Extron electronics Quantum Ultra Series User Manual page 43

Custom output resolutions
Using the VCS program, you can add custom output resolutions based on EDID that have
either been captured from the connected sink device on an output or uploaded (see the
VCS Help File for information on managing EDID).
NOTES: The following notes apply only to the OUT4HDMI and DTP output cards,
not the OUT4HDMI 4K PLUS card.
• If the EDID pixel clock is greater than 165 MHz, you are not able to assign the
resolution to output connectors 1 and 3 (see the VCS Help File for instructions on
managing EDID).
• If the custom resolution does not work, the pixel clock may need to be
adjusted in order to be supported by the HyperLane bus.
representative for assistance.
Output grouping and canvases
The VCS program provides screen workspaces called canvases (or output groups) on
which to design the videowall.
Figure 26. Canvas Example
A canvas contains a grid diagram in which each cell shows the following information
about a display on the videowall:
1 1 1
2 2 2
3 3 3
1.
4 4 4
Figure 27. Canvas Cell Contents Example
Location coordinates of the display on the wall in pixels (see figure 27,
•
• Display number (displays are numbered horizontally on the canvas,
• Name of the Quantum Ultra Series device to which the display is connected (
Displays on a videowall can be connected to different processors.
• Number of the output card slot on the chassis, followed by the output connector
number to which the display is connected (
• Output resolution (
5
Quantum Ultra Series Videowall Processing Systems • Installation and Configuration
5 5 5
).
4
)
Contact an Extron
)
1
).
2
).
3
35