Extron electronics Quantum Ultra Series User Manual page 83

Command
Advanced Configuration, continued
Power Save
Power save off
Power save on
View power save status
NOTE: When power save is disabled, the Quantum Ultra reboots, and network connections must be re-established.
KEY:
X6@
= Power save status: 0 = off (full power mode, default), 1 = power save on.
Resets
Reboot system and save
network settings
Reboot system and
discard network settings
System reset (soft reset)
Absolute system reset
but retain IP settings.
Absolute system reset
Quantum Ultra Series Videowall Processing Systems • Remote Configuration and Control
ASCII Command
(Host to Processor)
E }
0 PSAV Psav 0
E }
1 PSAV Psav 1
E } X6@ ]
PSAV
In verbose modes 2 and 3:
Psav
E }
1 BOOT Boot 1
E }
3 BOOT Boot 3
E }
ZXXX Zpx
E }
ZY Zpy
E }
ZQQQ Zpq
Response
(Processor to Host)
]
]
X6@ ]
]
]
]
]
]
Additional Description
The Quantum Ultra runs in full
power mode (default).
The unit enters low power state
that can be exited only via the
Power Save Off command or a
power cycle.
View current power save status
X6@
.
Reboot the system and retain
the network settings.
Reboot the system and discard
the network setting changes.
Reset all device settings to
factory defaults.
The project file is deleted and
the unit is rebooted to commit
and clear video outputs. IP
configuration and picture files
remain untouched.
Set all device settings to factory
defaults except the IP address,
subnet mask, gateway
address, DHCP, and port
mapping.
The project file is deleted, the
picture folder is reset to default
images, and the unit is rebooted
to commit and clear video
outputs. The IP configuration
remains untouched.
Set all device settings plus
DHCP and the IP address to
factory defaults.
The project file is deleted, the
picture folder is reset to default
images, the IP configuration is
reset to default, and the unit is
rebooted to commit and clear
video outputs.
This command also removes
the initial factory-configured
serial number password, and
resets it to extron.
75