Operation; Starting The Control Panel - Extron electronics Quantum Ultra Series User Manual

Operation

The Quantum Ultra Series processor is a host device with an embedded operating
system. The Control Panel is a program that resides on the Quantum Ultra Series
operating system and enables you to perform various setup and maintenance tasks, such
as setting the processor IP address, resetting the device, or updating the firmware.
This section discusses the functions accessed via the Control Panel:
•
•
•
•
•
•
•
•
•
•

Starting the Control Panel

To access the Quantum Ultra Series Control Panel:
1.
2.
3.
Starting the Control Panel
Buttons on the Control Panel
Loading Image Files
Updating the Password
Updating Firmware
Modifying Network Settings from the Control Panel
Resetting the Device from the Control Panel
Service Mode
Disabling and Enabling Write Protection
Shutting Down the Device
Connect a USB keyboard and mouse to the USB system connectors on the rear
panel (see figure 45). You can also connect a USB flash drive to a USB system
connector to load and manage picture files or upload new firmware.
HDMI Out Port
for Monitor
Figure 45. System Ports for Keyboard, Mouse, and Monitor
Connect a monitor to the HDMI Out system connector on the rear panel. A login
window opens with the user name displayed (by default, this name is admin).
Enter the password where indicated on the login window (by default, the password is
extron).
NOTE: The factory configured passwords for all accounts on this device have
been set to the device serial number. In the event of an absolute system reset,
the passwords convert to the default, which is extron.
Quantum Ultra Series Videowall Processing Systems • Operation
SYSTEM
USB Ports for Keyboard,
Mouse, or Flash Drive
49