2.
Use a screwdriver to loosen the thumbscrew on the drive (see figure 103,
rotating it to the left.
NOTE: The thumbscrews cannot be removed completely.
2
Slide the hard drive out.
Figure 103.
ATTENTION:
•
Thumbscrews should be tightened with a screwdriver after both initial
installation and subsequent access to the panel.
•
Les vis doivent être serrées avec un tournevis après la première installation
et l'accès postérieur au panneau.
3.
Grasp the thumbscrew firmly and pull the drive straight toward you until it is free (see
figure 103,
Quantum Ultra Series Videowall Processing Systems • Maintenance — Quantum Ultra 610 Only
1
Loosen the thumbscrew
Removing the Disk Drive
).
2
) by
1
107