Extron electronics Quantum Ultra Series User Manual page 97

Adding expansion devices manually
If the desired expansion device does not appear on the NewProject discovery screen,
add the expansion system manually as follows:
1. On the NewProject connection screen, click the Manually Add Device button (see
figure 73, on page 85.
3
On the Manually Add Device window, click the Manually Configure Expansion
2.
button (see figure 82,
Figure 82. Manually Add Device Window
3. On the Manually Configure Expansion screen, enter the IP addresses of the
devices in the expansion. Be sure to enter the addresses in the order the devices
are connected in the chain, with the primary device address in the top (first) field (see
figure 83, ).
1
Figure 83. Manually Configure Expansion Screen
4. Click Confirm (
2
the expansion system as a single item on the device list with the model name
Quantum Ultra Expansion (see figure 80,
5. Go to step 4 of the "Starting the VCS Program with Expansion Cards" procedure on
the previous page, and complete the procedure as described.
NOTE: If the Quantum Ultra Expansion line does not appear on the connection
screen, add the primary device manually (see
the Select Device(s) to Add panel
Quantum Ultra Series Videowall Processing Systems • Remote Configuration and Control
). Ignore the other fields.
1
). The system restarts, then after approximately 2 minutes displays
1
on page 85).
on page 87).
If you do not see your device in
89