Extron electronics Quantum Ultra Series User Manual page 103

2. On the processor rear panel, loosen the two thumbscrews at the right and left edges
of the card to be removed (see
3.
Slide the card out of the chassis.
4. Inside the card slot are guides on both sides to ensure the replacement card is aligned
correctly. Slide the new card into the slot with its side edges in the card guides. Press
the card firmly into place, so that its outside edge is flush with the rear panel of the
chassis.
Slide the card in
between the side guides.
Figure 87.
NOTE: The card is not completely in place until you hear or feel it snap into the
connector at the end of the card. If you do not feel it snap into position, press on
it more firmly until you do.
Quantum Ultra Series Videowall Processing Systems • Maintenance — Quantum Ultra 610 Only
figure 88
Guide
Input or Output Card Guides
on page 96 for the locations).
95