Maintenance; Front Panel - Quantum Ultra And Ultra Ii 610; Accessing The Quantum Ultra And Ultra Ii 610 Front Panel - Extron electronics Quantum Ultra Series User Manual

Maintenance

The Quantum Ultra 610 has several parts that you can replace, should they fail, wear out,
or no longer meet your requirement. On the Quantum Ultra 305, only the input and output
cards can be replaced. The Quantum Ultra Connect models have no user-replaceable
parts, therefore, these maintenance procedures do not apply to them.
This section provides instructions for replacing these parts, which you can order from
your Extron representative or by going to www.extron.com. All these replacements are
performed from the front panel.
The following topics are discussed in this section:
•
•
•
•
•
•
Front Panel — Quantum Ultra and Ultra II 610

Accessing the Quantum Ultra and Ultra II 610 Front Panel

To access the Quantum Ultra and Ultra II 610 front panel, open the front panel door as
follows:
1.
Quantum Ultra Series Videowall Processing Systems • Maintenance — Quantum Ultra 610 Only

Front Panel - Quantum Ultra and Ultra II 610

Replacing Input and Output Cards
Replacing a Power Supply - Quantum Ultra and Ultra II 610
Replacing the Power Supply Front Fan - Quantum Ultra 610 Only
Replacing a Disk Drive - Quantum Ultra and Ultra II 610
Replacing the System Board Computer (SBC) Assembly - Quantum Ultra and
Ultra II
Insert a coin, such as a penny, in the slot on the front panel lock and rotate it one
quarter turn counterclockwise, until the dot above the slot faces Open.
LOCK
LOCK
OPEN
OPEN
Figure 84. Front Panel Door Lock
91