4.
Use a screwdriver to loosen the thumbscrews at the right and left edges of the
assembly (see figure 106,
ATTENTION:
•
Thumbscrews should be tightened with a screwdriver after both initial
installation and subsequent access to the panel.
•
Les vis doivent être serrées avec un tournevis après la première installation
et l'accès postérieur au panneau.
5.
Pull the handle on the SBC (
Figure 106.
Quantum Ultra Series Videowall Processing Systems • Maintenance — Quantum Ultra 610 Only
). The thumbscrews cannot be removed completely.
1
) toward you until the assembly is free of the chassis.
2
1 1
Removing the SBC Assembly
Loosen the thumbscrews (2).
1 1
2 2
110