Outbound Blacklist - Grandstream Networks UCM6206 User Manual

Send This Call Through Trunk
Use Trunk
Strip
Prepend
Use Failover Trunk
Failover Trunk
Strip
Prepend
Time Condition
Time Condition

Outbound Blacklist

The UCM6200 allows users to configure blacklist for outbound routes. If the dialing number matches the blacklist
numbers or patterns, the outbound call will not be allowed. The outbound blacklist can be configured under UCM
web UI->PBX->Basic Call/Routes->Outbound Routes: Outbound Blacklist.
Users can configure numbers, patterns or select country code to add in the blacklist. Please note that the blacklist
settings applies to all outbound routes.
Example: [12345-9] - Any digit from 1 to 9.
Select the trunk for this outbound rule.
Allows the user to specify the number of digits that will be stripped from the
beginning of the dialed string before the call is placed via the selected trunk.
Example:
The users will dial 9 as the first digit of a long distance calls. However, 9 should
not be sent out via analog lines and the PSTN line. In this case, 1 digit should be
stripped before the call is placed.
Specify the digits to be prepended before the call is placed via the trunk. Those
digits will be prepended after the dialing number is stripped.
Failover trunks can be used to make sure that a call goes through an alternate
route, when the primary trunk is busy or down. If "Use Failover Trunk" is enabled
and "Failover trunk" is defined, the calls that cannot be placed via the regular trunk
may have a secondary trunk to go through.
UCM62XX support up to 10 failover trunks.
Example:
The user's primary trunk is a VoIP trunk and the user would like to use the PSTN
when the VoIP trunk is not available. The PSTN trunk can be configured as the
failover trunk of the VoIP trunk.
Allows the user to specify the number of digits that will be stripped from the
beginning of the dialed string before the call is placed via the selected trunk.
Example:
The users will dial 9 as the first digit of a long distance calls. However, 9 should
not be sent out via analog lines and the PSTN line. In this case, 1 digit should be
stripped before the call is placed.
Specify the digits to be prepended before the call is placed via the trunk. Those
digits will be prepended after the dialing number is stripped.
Users could customize holiday time, office time or a specified time to allow the
outbound route to be used.
UCM6200 Series User Manual
P a g e | 182