Create New Fxs Extension; Table 41: Iax Extension Configuration Parameters->Specific Time; Table 42: Fxs Extension Configuration Parameters->Basic Settings - Grandstream Networks UCM6206 User Manual

If the end point also has a ring timeout configured, the actual ring timeout used is the
shortest time set by either device.
Enable automatic recording for the calls using this extension. The default setting is
disabled. The recording files can be accessed under web GUI->CDR->Recording
Auto Record
Files.
•
•
Skip Trunk Auth
•
Time Condition for If "Skip Trunk Auth" is set to "By Time", select a time condition during which users can
Skip Trunk Auth skip entering password when making outbound calls.
Dial Trunk
Configure personal password when making outbound calls via trunk.
Password
Enable LDAP If enabled, the extension will be added to LDAP Phonebook PBX lists.
Configure the Music On Hold class to suggest to the bridged channel when putting
Music On Hold
them on hold.
Call Duration Limit The maximum duration of call-blocking.
Specific Time
Time Condition Click to add Time Condition to configure specific time for this extension.

Create New FXS Extension

The UCM6200 supports Foreign eXchange Subscriber (FXS) interface. FXS is used when user needs to connect
analog phone lines or FAX machines to the UCM6200.
To manually create new FXS user, go to Web GUI->PBX->Basic/Call Routes->Extensions. Click on "Create
New User"->"Create New FXS Extension" and a new dialog window will show for users to fill in the extension
information. The configuration parameters are as follows.
General
Extension The extension number associated with the user.
Analog Station Select the FXS port to be assigned for this extension.
Configure the CallerID Number that would be applied for outbound calls from this
Caller ID Number user. Note:
The ability to manipulate your outbound Caller ID may be limited by your VoIP
If set to "Yes", users can skip entering the password when making outbound calls.
If set to "By Time", users can skip entering the password when making outbound
calls during the selected time condition.
If set to "No", users will be asked to enter the password when making outbound
calls.
Table 41: IAX Extension Configuration Parameters->Specific Time
Table 42: FXS Extension Configuration Parameters->Basic Settings
UCM6200 Series User Manual
P a g e | 134