Grandstream Networks UCM6206 User Manual page 172

Enable Heartbeat If enabled, the UCM6200 will regularly send SIP OPTIONS to the device to check
Detection if the device is still online. The default setting is "No".
When "Enable Heartbeat Detection" option is set to "Yes", configure the interval
Heartbeat Frequency (in seconds) of the SIP OPTIONS message sent to the device to check if the device
is still online. The default setting is 60 seconds.
Maximum Number of The maximum number of concurrent calls using the trunk. The default settings 0,
Call Lines which means no limit.
Select Fax mode. The default setting is "None".
•
•
Fax Mode
SRTP Enable SRTP for the VoIP trunk. The default setting is "No".
If enabled, the local UCM6200 will automatically provide and update the local
LDAP contacts to the remote UCM6200 SIP peer trunk. In order to ensure
Sync LDAP Enable
successful synchronization, the remote UCM6200 peer also needs to enable this
option on the SIP peer trunk. The default setting is "No".
This is the password used for LDAP contact file encryption and decryption during
Sync LDAP
the LDAP sync process. The password must be the same on both UCM6200 peers
Password
to ensure successful synchronization.
Sync LDAP Port Configure the TCP port used LDAP sync feature between two peer UCM6200.
Specify an outbound rule for LDAP sync feature. The UCM6200 will automatically
LDAP Outbound Rule
modify the remote contacts by adding prefix parsed from this rule.
Specify the prefix for LDAP sync feature. The UCM6200 will automatically modify
LDAP Dialed Prefix
the remote contacts by adding this prefix.
CC Settings
If enabled, the system will automatically alert the user when a called party is
Enable CC
available, given that a previous call to that party failed for some reason.
Configure the maximum number of CCSS agents which may be allocated for this
CC Max Agents channel. In other words, this number serves as the maximum number of CC
requests this channel is allowed to make. The minimum value is 1.
Configure the maximum number of monitor structures which may be created for
CC Max Monitors
this device. In other words, this number tells how many callers may request CC
•
Inband: Send DTMF using inband audio. This requires 64 bit codec, i.e.,
PCMU and PCMA.
•
Auto: Send DTMF using RFC2833 if offered. Otherwise, inband will be
used.
None: Disable Fax.
Fax Detect: Fax signal from the user/trunk during the call can be detected and
the received Fax will be sent to the Email address configured for this
extension. If no Email address can be found for the user, the Fax will be sent
to the default Email address configured in Fax setting page under web UI-
>PBX->Internal Options->Fax/T.38.
UCM6200 Series User Manual
P a g e | 171