Grandstream Networks UCM6206 User Manual page 168

Line and TO header in the SIP request to indicate the E.164 number. If set to
"Enable", "Tel:" will be used instead of "SIP:" in the SIP request. The default setting
is disabled.
Select whether the trunk needs to register on the external server or not when
Need Registration
"Register SIP Trunk" type is selected. The default setting is No.
If enabled outgoing calls even if the registration to this trunk fail will still be able to
Allow outgoing calls
go through.
if registration failure
Note that if we uncheck "Need Registration" option, this option will be ignored.
Configure the new name of the caller when the extension has no CallerID Name
CallerID Name
configured.
Configure the actual domain name where the extension comes from. This can be
used to override the "From" Header.
From Domain
For example, "trunk.UCM6200.provider.com" is the From Domain in From Header:
sip:1234567@trunk.UCM6200.provider.com.
Configure the actual user name of the extension. This can be used to override the
"From" Header. There are cases where there is a single ID for registration (single
From User trunk) with multiple DIDs.
For
sip:1234567@trunk.UCM6200.provider.com.
Enter the username to register to the trunk from the provider when "Register SIP
Username
Trunk" type is selected.
Enter the password to register to the trunk from the provider when "Register SIP
Password
Trunk" is selected.
Auth ID Enter the Authentication ID for "Register SIP Trunk" type.
If enabled, the UCM will send 401 response to the incoming call to authenticate
Auth Trunk
the trunk.
Enable automatic recording for the calls using this trunk (for SIP trunk only). The
Auto Record default setting is disabled. The recording files can be accessed under web GUI-
>CDR->Recording Files.
Advanced Settings
Select audio and video codec for the VoIP trunk. The available codecs are: PCMU,
Codec Preference PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723, iLBC, ADPCM,
H.264, H.263, H.263p and VP8.
If enabled, the SIP INVITE message sent to the trunk will contain PPI (P-Preferred-
Identity) header. The default setting is "No".
Send PPI Header Note:
"Send PPI Header" and "Send PAI Header" cannot be enabled at the same time.
Only one of the two headers is allowed to be contained in SIP INVITE message.
example, "1234567" is
UCM6200 Series User Manual
the From User in From Header:
P a g e | 167