Sega TETRIS GIANT Owner's Manual page 57

48
ASSEMBLY AND INSTALLATION
7
The controller cabinet has 4 casters and 4 adjusters. Make sure that all the adjusters are in contact with the
floor directly. Use a wrench to set adjuster heights so that the controller cabinet will stay level.
6
8
Fully tighten the hexagon bolts that were lightly tightened and fasten joint bracket R to the foot frame.
Fasten bracket L on the other side in the same way.
HEXAGON BOLT (2), black
M8 x 20, w/flat & spring washers, large flat washer used
9
Remove the 2 truss screws, unlock the projector door with the master key, and take it off.
TRUSS SCREW (2), chrome
M4 x 30, large flat washer used
ADJUSTER
Tighten nut upwards.
ADJUSTER
CASTER
ADJUSTER
PROJECTOR DOOR
CASTER
About 5 mm (0.2 in)
Unlock.