Lamp Replacement - Sega TETRIS GIANT Owner's Manual

11-3 LAMP REPLACEMENT

When replacing the lamp, use only special projector lamps. Using any other lamp
could result in serious accidents including fires.
● The lamp will be very hot immediately after use. Do not touch it or you could be
burned. Wait at least an hour for the lamp to cool off before replacing it.
● The lamp is made with glass, so do not touch it with bare hands, subject it to
heavy impact, or scratch it. Dirt, scratches, and heavy impact can break the
lamp, resulting in injury.
● If the lamp breaks, be careful not to cut yourself with the broken pieces of glass.
If the lamp breaks inside the projector, contact the office listed in this manual or
the point-of-purchase for this product.
● The projector (200-6155) in this product requires a special lamp (200-6156). Do
not use lamps with other part numbers.
● After replacing the lamp, reset the "Lamp Timer (Hours of Lamp Use.)" Refer to
the included manual (CD) for instructions on how to perform the reset operation.
● The lamp contains a minute amount of inorganic mercury, which is harmful to
the environment. When disposing of used lamps, be careful not to break them,
and do so according to the rules and regulations set forth by the local authority.
Contact your local authority for details.
To replace the lamp, refer to "6-2-1 Attaching the Projector" and work in reverse order to take the projector out of
the controller cabinet.
Refer to the included manual (CD) for instructions on how to replace the lamp.
111
PROJECTOR
11