Precautions Regarding Installation Location; Limitations Of Usage - Sega TETRIS GIANT Owner's Manual

PRECAUTIONS REGARDING INSTALLATION LOCATION

2
This product is an indoor game machine. Do not install it outside. Even indoors,
avoid installing in places mentioned below so as not to cause a fire, electric
shock, injury and/or malfunction.
- Places subject to rain or water leakage, or places subject to high humidity in the
proximity of an indoor swimming pool and/or shower, etc., or places where a
water jet (high pressure washing device) could be used.
- Places subject to direct sunlight, or places subject to high temperatures in the
proximity of heating units, etc.
- Places filled with inflammable gas or vicinity of highly inflammable/volatile
chemicals or hazardous matter.
- Dusty places.
- Sloped or unstable surfaces.
- Places subject to any type of violent impact.
- Vicinity of anti-disaster facilities such as fire exits and fire extinguishers.
- Areas where the temperature exceeds the applicable temperature (ambient
temperature) range of 5 to 30 degrees centigrade (41 to 86 degrees Fahrenheit.)

2-1 LIMITATIONS OF USAGE

● Be sure to check the electrical specifications. Ensure that this product
is compatible with the location's power supply, voltage, and frequency
requirements. A plate describing electrical specifications is attached to the
product. Non-compliance with the electrical specifications can cause a fire and
electric shock.
● This product requires a breaker and earth mechanism as part of the location
facilities. Using the product without these can cause a fire and electric shock.
● Be sure to use an independent power supply equipped with an earth leakage
breaker. Using a power supply without an earth leakage breaker can cause an
outbreak of fire if a power surge occurs.
● Putting many loads on one electrical outlet can cause generation of heat and a
fire resulting from overload.
● Ensure that the indoor wiring for the power supply is rated at 15 A or higher (AC
single phase 100 V ~ 120 V area), and 7 A or higher (AC 220 V ~ 240 V area). Non-
compliance with the electrical specifications can cause a fire and electric shock.
● When using an extension cord, ensure that the cord is rated at 15 A or higher (AC
100 V ~ 120 V area) and 7 A or higher (AC 220 V ~ 240 V area). Using a cord rated
lower than the specified rating can cause a fire and electric shock.
PRECAUTIONS REGARDING INSTALLATION LOCATION
5
2