Sega TETRIS GIANT Owner's Manual page 151

142
SWITCHING TO A NAOMI BOARD
5
Connect the attached wires (DKC-60036, DKC-60037, DKC-60038) to the NAOMI board and affix it in
place using the 3 cord clamps.
6
Put the base loaded with the NAOMI board inside the back door and fasten it in place with 2 screws. Be
careful not to damage the wires when doing so.
18
7
Connect the 2 connectors to the NAOMI board.
Fasten D-SUB 15P in place with 2 fastening screws. After
connecting the connector, fasten it in place with a cord clamp.
Connect the connector.
VL6P, VL8P, Audio L/R
Fasten in place with cord clamp.
Connect the connector.
D-SUB 15P, JVS
Fasten in place with cord clamps.
(3)
SCREW (2)
M4×30, w/flat & spring washers