Sega TETRIS GIANT Owner's Manual page 43

34
ASSEMBLY AND INSTALLATION
4
Set down the projector as shown in the figure and retighten the 2 wing bolts that were loosened in Step 1
as well as the 2 wing bolts that were removed. Line up the tops of the 2 metal plates when fastening the
projector in place.
6
Front: WING BOLT (2)
M4 x 10, large flat & spring washers used
Line up the tops of the 2 metal plates.
5
Remove the 2 truss screws, unlock the projector door with the master key, and take it off.
TRUSS SCREW (2), chrome
M4 x 30, large flat washer used
Back: WING BOLT (2)
M4 x 10, large flat & spring washers used
PROJECTOR DOOR
Unlock