Sega TETRIS GIANT Owner's Manual page 150

4
Place the NAOMI board on the base (wooden plate) as shown in the figure. Affix the NAOMI board using
removed 4 tapping screws.
NOTE: If you have a NAOMI board + GD-ROM, refer to the figure below and fasten only the NAOMI board in
place as the base.
TAPPING SCREW (4)
3.5 x 16
NAOMI BOARD
Stand-alone NAOMI board
GD-ROM DRIVE
35 mm
(1.4 in)
NAOMI BOARD
372 mm (14.6 in)
Position of prepared holes (reference)
SWITCHING TO A NAOMI BOARD
NOTE: It will touch the square piece of wood inside the
back door, so leave 11 mm (0.4 in) of space.
20 mm
178 mm
(0.9 in)
(7.0 in)
30 mm (1.2 in)
36 mm (1.4 in)
10 mm
(0.4 in)
SQUARE PIECE OF WOOD
141
18