Assembling The Controller Cabinet; Attaching The Projector - Sega TETRIS GIANT Owner's Manual

6-2 ASSEMBLING THE CONTROLLER CABINET

6-2-1 Attaching the Projector

1
Remove the 2 wing bolts on the front of the projector base and loosen the 2 wing bolts on the back to open
the projector base.
Back: WING BOLT (2)
M4 x 10, large flat & spring washers used
Front: WING BOLT (2)
M4 x 10, large flat & spring washers used
2
Lay out some protective material and place the
projector on it upside down.
3
Place the projector base on the projector as
shown in the figure and fasten it in place with
3 screws.
PROJECTOR
SCREW (3)
M4 x 10, w/flat & spring washers
ASSEMBLY AND INSTALLATION
33
6