Replacing The Shaft Stopper (With 8-Direction Stopper) - Sega TETRIS GIANT Owner's Manual

144

REPLACING THE SHAFT STOPPER (WITH 8-DIRECTION STOPPER)

REPLACING THE SHAFT STOPPER (WITH 8-DIRECTION STOPPER)
19
When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
When fastening plastic parts, be careful not to tighten screws and nuts
excessively. Otherwise parts may be damaged, resulting in injuries from
fragments, etc.
The supplied shaft stopper is used for game software that requires an 8-direction stopper.
After the original stopper is replaced, the joystick will move in 8 directions. Check the specifications of the game
software before replacing the stopper.
NOTE: This product (TETRIS GIANT) requires a 4-direction stopper, so do not replace it with the supplied shaft
stopper (8-direction).
This work should be performed with at least one other person to keep from dropping parts.
1
Turn the power off.
2
Remove the 6 tamperproof screws and lift up the joystick ball to take it off. The wires are still connected
at this point, so be careful not to damage them.
19
Shaft Stopper (4-direction)
TAMPERPROOF SCREW (6), chrome
M5×8
Shaft Stopper (8-direction)
JOYSTICK BALL