Notes Related To The Projector - Sega TETRIS GIANT Owner's Manual

11-1 NOTES RELATED TO THE PROJECTOR

● When turning on the power again, wait about 5 minutes until the projector lamp
cools off. If the power is turned on before the lamp cools, it will take several
minutes before the screen is shown. Also, note that turning the power switch to
the ON position immediately after turning it to the OFF position can damage the
projector.
● The average life of a high-pressure mercury lamp in energy-saving mode (the
default setting) is approximately 3,000 hours. This is based on the average time it
takes for it to go down to 50%. A life of 3,000 hours does not mean that the lamp
cannot last beyond 3,000 hours. The actual life may vary depending on how it is
used.
● The lamp is a consumable part. If used for an extended amount of time, the image
may become dark or it may go out and not come back on. This is a characteristic
of the lamp and is not a defect.
● Replace the lamp every 3,000 hours or so (approximately 7 months at 14 hours of
operation a day).
● If the lamp goes out, the projector screen will go blank, and the game will not
work. Always have a spare lamp available by ordering a new one or extras
immediately after replacing the lamp.
● The projector (200-6155) in this product requires a special lamp (200-6156). Do
not use lamps with other part numbers.
This product is equipped with an industrial projector to display the game on the screen.
Instructions for operating the projector and other information can be found in the included manual (CD). Refer to it
when configuring the settings and making adjustments.
How to operate the remote control
Open the service door and point the remote control towards the back of the projector inside the cabinet.
Function settings
The projector has various functions with many different settings. The settings necessary for this product have already
been configured, so it is normally not necessary to make changes. If the settings are changed accidentally, change
them back as follows [refer to the included manual (CD)]:
- Menu → Projection Settings → Direct Power on: ON
- Menu → Projection Settings → Energy-saving mode: ON
Use the factory defaults for the other settings.
There is an item on the status display menu, "Lamp Timer (Hours of Lamp Use)," which can be used to check how
many hours the lamp has been used.
109
PROJECTOR
11