Aligning The Needle Bar Linkage In The Sewing Direction - DURKOPP ADLER 867 Service Instructions Manual

Aligning the needle bar linkage

9.2 Aligning the needle bar linkage in the sewing direction

Fig. 31: Aligning the needle bar linkage in the sewing direction
(1) - Machine arm surface
(2) - Lever
(3) - Center of bolt
Proper setting
Stitch length adjusting wheels to 0.
 The lever (2) is positioned so that the distance from the surface of
To align the needle bar linkage in the sewing direction:
1. Disassemble the valve cover ( p. 17).
2. Tilt the machine head ( p. 14).
3. Set the lower stitch length adjusting wheel to 0.
4. Set the upper stitch length adjusting wheel to 0.
5. Loosen the threaded pins (4).
6. Loosen the screw (5).
7. Position the lever (2).
8. Tighten the threaded pins (4).
9. Tighten the screw (5).
Service Instructions 867 - 04.0 - 10/2019
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before aligning the needle
bar linkage.
①
②
the arm (1) to the center of the bolt (3) is 123.6 mm.
③
(4) - Threaded pins
(5) - Screw
⑤
④
47