Show Mac - Enterasys Matrix E1 1G694-13 Configuration Manual

9.2.3.7

show mac

Use this command to display MAC addresses contained in the device's source address table.
show mac [address mac address] [fid vlan_Id ] [port port_string] [type {learned
| self | mgmt}]
Syntax Description
address
mac address
fid
vlan_id
port
port_string
type
Command Defaults
If no parameters are specified, all MAC addresses for the device will be displayed.
Command Mode
Read-Only.
(Optional) Specifies that the MAC address designated by
mac address will be shown.
(Optional) Specifies the MAC address to be shown (if it is
known by the device).
(Optional) Specifies that MAC addresses for a filter
database identifier as designated by vlan_id will be shown.
(Optional) Specifies the number identifying the VLAN.
(Optional) Specifies the MAC addresses for the port(s)
designated by port_string will be shown.
(Optional) Specifies the port designation for which to show
MAC addresses. For a detailed description of possible
port_string values, refer to
(Optional) Specifies that addresses of only a certain type
will be shown. Valid types are:
•
learned Show the addresses of type learned only.
•
self Show the addresses of type self only.
•
mgmt Show the addresses of type mgmt only.
Matrix E1 Series (1G694-13) Configuration Guide
Network Management
Managing Network Addresses and Routes
Section 4.1.2.
9-31